Omnia-6ex Use and Operation Manual – V: 1.20
9
Digital Audio Input:
Configuration: Stereo per AES/EBU standard, CS8420 Digital Audio
Transceiver with 24 bit resolution, software selection of stereo, mono
from left, mono from right or mono from sum. Automatically accepts
and locks to input sample rates between 8 and 108 kHz.
Connector:
XLR-female, EMI-suppressed. Pin 1 chassis ground, pins 2 and 3
transformer
isolated,
balanced,
and floating – AES3 standard 110 ohm
impedance.
Digital Audio Output
#1:
Stereo per AES3 standard. Output can be configured in software for flat
or pre-emphasized response at 50 or 75 microseconds.
Digital Sample Rates: Output sample rates software selectable for
32kHz, 44.1kHz, 48kHz, and 96 kHz.
Connector:
XLR-male, EMI-suppressed. Pin 1 chassis ground, pins 2
and 3 transformer isolated, balanced, and floating. Standard AES3
specified 110 ohm source impedance.
Digital Output Level: -22.0 to 0.0 dBFS software adjustable.
Digital Audio Output
#2:
Stereo per AES3 standard. Output can be configured in software for flat
or pre-emphasized response at 50 or 75 microseconds.
Digital Sample Rates: Output sample rates hardware jumper selectable for
32kHz, 44.1kHz, 48kHz, or 96 kHz, or its rate slaved to AES #1.
Connector:
XLR-male, EMI-suppressed. Pin 1 chassis ground, pins 2
and 3 transformer isolated, balanced, and floating. Standard AES3
specified 110 ohm source impedance.
Digital Output Level: -22.0 to 0.0 dBFS software adjustable.
Digital Sync Input:
External Sync: Output sample rate can be synchronized to the signal
present on the AES/EBU input, or to an AES3 signal applied to the Ext.
Sync
input
connector.
(does
not accept Word Clock inputs)
External Sync Range: Accepts sample rates from 32kHz to 96 kHz.
Used for synchronization of the Digital Output signal to an external
reference. Automatically accepts sample rates between 32 and 96 kHz.
Connector:
XLR-female,
EMI-suppressed. Pin 1 chassis ground, Pin 2-3
transformer
isolated,
balanced,
and floating. Standard AES3 specified
balanced 110 ohm input impedance.
Note: If AES Output #2 is slaved to AES Output #1 (hardware jumper) and
External Sync is selected for AES #1, then AES Output #2 becomes slaved to
the sample rate of the Sync input for AES Output #1.
Remote Control
Methods
:
Configuration: Modem, Direct Serial, or 10/100BaseTX Ethernet.
Modem: Optional PCMCIA modem with pop-out X-jack connector or any
Hayes command set compatible external modem.
Direct
Serial:
Standard
RS-232,
no
hardware handshaking employed.
Baud rates of 9,600, 19,200, and 57,600 supported.
TCP/IP Ethernet: Emulates a Telnet session on Port 23.
Connectors: RS-232 port, EMI-suppressed DB-25 female connector.
Industry standard EMI suppressed RJ-45 connector for Ethernet.
