NOTE:
The system should be installed with all peripherals attached, to mount the assembly as a
single block. It is strongly recommended to install the antenna so that its axis is vertical
with respect to the ground, as this favors the range of the signals transmitted by the
device.
Consider clearing a square area, of 25 cm at each side, of the plane in which the
Datalog X-PRO needs to be installed. Mount the system near the center of said clear
space
, to leave enough margins to comfortably install its peripherals, as shown below:
Figure 2-6 Recommended free space around the Datalog X-PRO
To secure the Main Unit enclosure to a wall:
1. Find the mounting holes covered by the blind lids at the top and bottom borders of
the Main Unit enclosure (3, in
Figure 2-7
)
2. Prepare the surface on which the Main Unit will be placed, taking into account the
distance between the holes previously found (which is 81mm).
3. Use M3 screws (nuts, washers, or plastic anchors, as needed) to fix the device where
it is required.
14
June
2023
