OMG D-RUN 120A, Manual

Page: 12 / 18

9 10
DR120AX2 车用无刷电子调速器功能说明
Series ESC information
我们的车用无刷电子调速器允许您针对自身需求来编程所有功能,充分
体现了产品以用户为本的特点。
Forward /Brake
This is a Race setting - Reverse is disabled.You will find in racing, most
tracks will not allow racing with reverse enabled.
正向与反向模式通常用于训练 双向带刹车（出厂默认 ） 双向无刹车
运行模式 Run Mode
注意：电调中有一个自动保护,即油门拉杆在第一次从自然位推到反向区域时,电调
只是刹车,不会有倒车动作;当把油门拉杆拉回自然位再次推至反向区域时
， 如果此
时车已停止,则产生倒车动作。因此只在您的车停止或是返回油门到自然位置时倒
车才有效
； 这样可防止电调误动作。
该功能防止电池过度放电而造成不可恢复的破坏。
根据您使用的电池，通过电脑软件或编程盒设置您的电池类型与低压
关断值；这样可使电调工作时随时监测电池电压，一旦电池电压低于
设置低压点，电调将降低功率。
当使用锂电时，出厂设定为每节放电不能少于
3.0V ，当使用 2s 锂电池
而电压低于 6V 时为低电压状态。
低电压关断值
Note: There is automatic protection within the RCOMG ESC. Only after
you have stopped and returned the trigger to neutral reverse will
become available. If while traveling in reverse, pull the trigger to go
forward. This is to help prevent serious damage to the drive train.
Forward /Brake/Reverse(Default)
If reverse is allowed in General Bashing around (FUN) or racing, the
Electronic Speed Controller requires 2 seconds of continuous neutral from
the transmitter prior to allowing reverse to operate.
Forward / Reverse
If the option is active, the RC car could go forward and backward, but
couldn't brake.
ESC– reverse operation
Should you get into a situation that requires reverse , after you have
applied any brakes you may have needed, return the throttle trigger to the
neutral position. Wait a moment or two and then push the trigger forward
for reverse.
Cut-off Voltage
Prevent the lipo batteries to over discharge. If the low voltage cutoff is
activated, the ESC detects the Voltage of the battery anytime and the
output power will be reduced to 20% in 3 seconds once the Voltage of the
battery is lower than the preset Low Voltage Cutoff Threshold . After
entering the voltage protection, Red LED blinks. When to be set 'Auto', the
ESC will detect the cell of batteries and set the Cut-off voltage to 3.0V/cell.
E.g.: when using 2s lipo, the low voltage threshold is 6.0V.
电调过热保护
ESC overheat protection
启用该功能后，当电调的温度达到过热保护设定值时，电调将降低功
率，而且蓝色
LED 灯会闪烁。
If the function is activated, the output power will be gradually reduced to
20% and the blue LED will blink when the temperature of ESC is up to the
preset option.
正向 )/反向( ) (Normal Reverse
马达转向
Motor Rotation
正向油门分段点/油门前段加速度/油门后段加速度
Switch Point /Punch Rate /Punch Rate 2