11 |
P a g e
Power Button
The Power Button is located on the top of the ZW -ED. (See
Figure 2.1
.) It allows for
rebooting and shutting down the ZW-ED. You may need to reboot the ZW-ED to have it
rejoin the network, if your Network ID, Device ID, Receiver, or Probe has changed, or if
a different RF Frequency is selected. To reset the ZW -ED, quickly press the power
button. When released the ZW-ED remunerates. The unit updates the Network ID and
Device ID, detects connected sensors, and searched for a Receiver.
Holding the reset switch for longer than 3 seconds will turn off the ZW -ED. When
holding the reset switch the blue LED turns on. When the blue LED turns off release the
switch and the unit will be powered off. Pressing the switch again will turn the unit back
on. Remove the Alkaline Batteries before long term storage of the ZW -ED.
Dimensions and Mounting
The ZW-ED includes all required hardware for mounting. To mount the ZW -ED,
position unit where required. Mark the location of the top center of the unit. Refer to
Figure 2.3
to mark and drill four pilot holes as indicated. Us e the included drywall
anchors if needed. Open the lid of the ZW-ED to access the mounting points. Use the
included screws to secure the ZW -ED.
Figure 2.3
–
Mounting Dimensions
•
When mounting the unit be sure to leave room on the top to access the Power
button and on the bottom and side for the Probe and Antenna.
•
Mount the unit away from any large metal obstructions such as posts, catwalks,
or large machinery.
•
For best wireless range do not co-locate the ZW-ED with other 2.4GHz wireless
equipment such as wireless routers or access points.
•
For best wireless range elevate the ZW-ED and keep a direct line of sight the
Receiver.
