4.3.6 Controller Setup
The Meter has two modes of operations. One is through the Front Panel Buttons
(please refer to
Front Panel Supplement
for more details), and the other is by
using the browser to configure the settings. Click on
from the Home
Page. In a few seconds the following page will appear.
Figure 4.14 Controller Setup
Controller
36
A
B
C
D
Channel #
Please refer to local regulations for the allowed maximum transmission power
Transmission Power
PID 13106 (version x.x)
iSeries Firmware Version x.x
Input
Setpoints & On/Off
Alarm 2
Analog Out
Passcode ID
Display
Permanent Store
Enable Standby Mode Before Configuring Unit
Scrolling
Main Menu
CONTROLLER SETUP
Setup
Transmission Power
Misc.
Monitor
CONTROLLER SETUP
http://192.168.1.200
Address
Update
Update
20dBm
End Device ID -
Reset Controller
Disable Standby
Enable Standby
This portion of
the menu will
be different
only if you have the
Analog Output Option
installed in your Meter.
Please refer to
local
regulations for
the maximum
allowed transmission
power.
