9 |
P a g e
•
Device Address:
If your Smart Interface is part of a Network, enter the Network Address here. The default network
address is 1 for most devices. Please refer to the manual of your Smart Interface for more
information.
Note:
The default Device Address is 1.
•
Device IP or Port:
The COM port number that your device is connected to on your computer.
Important:
The following parameters should
NOT
be changed. These settings should
NOT
be changed unless the
configuration has been done on the interface.
•
BaudRate:
Controls bits per second
•
DataBits:
The number of ‘bits’ in each character sent.
•
Parity:
A means of checking correctness of character by adding an extra ‘bit’ to the character and setting the value
based on all the other bits in the character.
•
StopBits:
The number of ‘bits’ used to indicate the end of the character.
Once you have completed setting the communication parameters for your device, click
Finish
.
4.3
Thermocouple Interface
The SP-005 provides interfaces to type J, K, T, E, N, R, S, B and C thermocouples with the capability of enabling or disabling
the open detect feature. To use these features, follow these steps:
Step 1:
Click the
Inputs
configuration tab on SYNC and choose your input type from the
Type
dropdown.
Step 2:
Click the input you wish to configure and select your thermocouple type from the
Device Range/Type
dropdown.
Step 3:
Click the
Open Detect
dropdown and choose to enable or disable it.
