![background image](http://html1.mh-extra.com/html/omega/smart-connector-uwrtd-series/smart-connector-uwrtd-series_user-manual_737501054.webp)
5.2 Mounting, Installation and Antenna Connection
5.2.1 Mounting
For UWTC-REC1, UWTC-REC2-D, UWTC-REC2, UWTC-REC3
Mounting ears or brackets are built-in to your receiver enclosure The diagram
below shows dimensions and mounting hole location. Rubber bumpers have
also been supplied with your receiver should you wish to use the device on a
desk or a work bench next to your PC.
TIP: Mounting your receiver on a wall away from your PC will provide better
signal strength and help to maximize system range.
When mounting your receiver, care should be taken to make sure it is as far
away from any metal objects. If nearby metal gets too close to your receivers
antenna, it has the potential to interfere with the way the unit receives data
and may cause signal lose or possibly even the inability to communicate at all
with your connector/transmitter.
For UWTC-REC3 mounting information, refer to the UWTC-REC3 Manual
(M4620).
Figure 5-16. Mounting
ANTENNA
USB
I/O
9–24 Vdc
OMEGA ENGINEERING, INC.
Stamford, CT 06907
UWTC SERIES
WIRELESS RF RECEIVER
2.4 GHz
omega.com
Made in U.S.A.
-
+
!
TX
RX
SB
PWR
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference;
2) This device must accept any interference received,
including interference that may cause undesired
operation.
FCC ID: OUR–XBEEPRO
IC #4214A–XBEEPRO
F
®
64 mm (2.5")
89 mm (3.5")
o 3.6mm
(0.140"
o 7.5mm
(0.295")
76 mm (3.0")
Mounting Hole Center Line
NOTE:
NOTE:
5-11
Receiver Operation
5