From this screen you will select the main operating settings for your
connector/transmitter. Start by selecting the type of Thermocouple you will be
using. Then select the address setting for this unit.
Each connector/transmitter must have a different address number than other units
in your system for proper operation).
Then select the sample rate that your unit will transmit data to the receiver.
After making your selections click the “Next >” button to proceed and
program your settings into connector/transmitter.
Congratulations! You have successfully programmed your connector
transmitter. After your unit has been programmed click the “Finish” button
to close the utility program or click the “Start” button to begin setting up a
second unit. You can now disconnect your connector transmitter from the
programming cable. Press the “Setup” button on the connector/transmitter one
time to exit the “Setup” mode.
Figure 4-11.
Send Settings
To End Device
Screen
4-8
Connector Operation
4
NOTE:
