5
Always feel the temperature of the water
before you enter in to the shower.
Do not leave disabled, elderly and children’s
unsupervised.
SAFETY SYSTEMS
OME 514-PV is equipped with the following
safety systems:
- Electronic Ignition-
Your unit will
never have a pilot light burning gas day and
night and wasting your gas and presenting
a fire danger
-
ION technologies –
This system read
the flame 20 times a minute, and detects
temperature of the flame. If the
temperature does not denote a fire, the unit
will attempt reigniting the flames. After the
second unsuccessfully attempt the system
will shut down your gas flow, therefore
eliminating discharging of unburned gas and
the danger of explosion.
-Pre-evacuation of existing gases
The unit will first start the interior air pump
and after the existing gases in the unit are
evacuated the unit will attempt ignition.
This process eliminates detonations in case
of any small leaks which can accumulate in
time.
The interior air pump will stringently
measure permanently the amount of air
necessary to burn the gas released on the
burning chamber, therefore the burning is
complete and efficient.
-This unit passes the most stringent
emission tests in the industry.
After you close your hot water faucet the air
pump will continue to work for up to 30
seconds to cool down the unit to eliminate
any possibility of overheating or heat
dissipation on the surrounding of the unit
therefore eliminating one more fire danger.
-Space age insulation:
-The entire unit is “Cold to touch” The
radiant temperature on any place on the
unit is under 100 F so the possibility of “Fire
by contact” is eliminated.
- Freeze Prevention-
We
see no reason to
install your water heater outside. OME 514-PV
is been design for inside installation so
therefore you do not need expensive and
energy consuming heat resistors to keep the
unit from freezing.
- Over pressure valve-
to eliminate any
possibility of water overpressure due to a
malfunction.
-
Alloy coating
Heater Exchanger is not exposed cooper like on
most of the units on the market, but is coated
with a special alloy which is able to sustain, with
out damage, temperatures in excess of 1500 F.
ALL of those safeties are incorporated in the
unit with only one reason in mind:
You, the customer!
INSTALLATION
Location
This instantaneous water heater is a complete,
perfect replacement kit system to replace your
old tank unit with out any plumbing
modification.
The recommended distances from immediate
walls or other object is as follow:
-4 inch from the sides,
-8 inches from the top, (ceiling or roof)
-3 inches from the front, (if enclosed in any
cabinet or wooden enclosure)
-24 inches from the floor, minimum, is required
by the fire codes but we recommend to have it
installed eyed site level for easy control,
supervision or maintenance.
- Use the 2 brackets provide for installation.
Find the studs and connect the 2 closest studs
together with the bracket. The water heater
does not need to be in the center of the
bracket.
Hang the water heater as needed on
any treaded hole in the bracket with the bolts
provided, one bolt on the top and 2 on the
bottom.
Water connections
-Use the same flex pipes you had on your old
tank water heater or replace them with new
ones if the old ones are rusted or damaged.
