26
ODWIS6015X
User Manual
Operation in case of emergency
In the event of an emergency you should:
•
Switch off the appliance using the Power button
•
Switch the appliance off at the power outlet and immediately unplug.
•
Call the Customer Service team on 1300 11 4357 or email [email protected]
Some minor faults can be fixed by referring to the instructions given in this Troubleshooting section.
There is also a self-help section online at https://support.residentiagroup.com.au
IMPORTANT:
If your appliance appears to be operating incorrectly, then you should disconnect it from your
electrical supply and then contact After Sales Support.
WARNING:
•
Do not attempt to repair the appliance yourself.
•
If overflow occurs, turn off the main water supply before calling a service.
•
If there is water in the base pan because of an overfill or small leak, the water should be removed before restarting
the dishwasher.
Please note that if an technician is asked to attend whilst the product is under warranty and finds that the problem
is not the result of an appliance fault, then you may be liable for the cost of the call out charge.
The appliance must be accessible for the engineer to perform any necessary repair.
If your appliance is installed in such a way that an engineer is concerned that damage will be caused to the appliance
or your kitchen, then they will not complete a repair. This includes situations where the rangehood has been tiled in
or sealed in with a sealant.
Please refer to the conditions of that appear on the warranty card at the rear of this user manual.
Error Codes
Code
Possible Cause
Solution
E1
Long inlet time.
Faucets may not be open, the water intake is restricted
or the water pressure is too low.
E3
Not reaching
required temperature.
Heating element could be malfunctioning.
E4
Overflow.
Some elemnt of the dishwasher is leaking.
E8
Failure of orientation
of distributary valve.
Open circuit or break of distributary valve.
Ed
Main circuit board and
display circuit board are
failing to communicate.
Open circuit or break wiring for communication.
Troubleshooting
