25
User Manual
Spray arms
It is necessary to clean the spray arms regularly for hard
water chemicals will clog the spray arm jets and bearings.
To clean the spray arms, follow the instructions below:
1. To remove the upper spray arm, hold the nut in the
center still and rotate the spray arm counterclockwise
to remove it.
2. To remove the lower spray arm, pull out the spray
arm upward.
3. Wash the arms in soapy and warm water and use a
soft brush to clean the jets. Replace them after rinsing
them throughly.
Caring For The Dishwasher
Frost precaution
Please take frost protection measures on the dishwasher
in winter. Every time after washing cycles, please operate
as follows:
1. Cut off the electrical power to the dishwasher
at the supply source.
2. Turn off the water supply and disconnect the water inlet
pipe from the water valve.
3. Drain the water from the inlet pipe and water valve. (Use a
pan to gather the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a
sponge to soak up water in the sump.
After every wash
After every wash, turn off the water supply to the appliance
and leave the door slightly open so that moisture and odors
are not trapped inside.
Remove the plug
Before cleaning or performing maintenance, always remove
the plug from the socket..
No solvents or abrasive cleaning
To clean the exterior and rubber parts of the dishwasher,
do not use solvents or abrasive cleaning products. Only use
a cloth with warm soapy water. To remove spots or stains
from the surface of the interior, use a cloth dampened
with water an a little vinegar, or a cleaning product made
specifically for dishwashers.
After prolonged inactivity
It is recommend that you run a wash cycle with the
dishwasher empty and then remove the plug from the
socket, turn off the water supply and leave the door of the
appliance slightly open. This will help the door seals to last
longer and prevent odours from forming within the appliance
Moving the appliance
If the appliance must be moved, try to keep it vertical.
If absolutely necessary, it can be positioned on its back.
Seals
Food can remained trapped in the seals which can cause
odours. Periodic cleaning with a damp sponge will prevent
this from occurring.
Cleaning & Maintenance
(Continued)