2.3 Parts of the iServer Unit
* Applies only to iBTHX models
Figure 2.3 Parts of the iServer Unit
Table 2.1 Parts of iServer Unit
SENSOR
DB9 or Screw Terminal Block Connections
ETHERNET
RJ45 interface for 10BASE-T connection.
RESET
Button: Used for power reseting the iServer.
ACTIVITY
LED (Red) Blinking: Indicates network activities (receiving or sending packets).
NET LINK
LED (Green) Solid: Indicates good network link.
DIAG
LED (Yellow and Green) Diagnostics: at boot-up they light up for 2 seconds, then
turn off; DHCP: if DHCP is enabled, they blink and stay solid periodically
POWER
LED (Green) Solid: Indicates Power-ON (for -W model only).
DC Power Supply Section:
+
Plus power supply wire connection (inside the plug for -W model).
-
Minus power supply wire connection (outside the plug for -W model).
iBTHX-D / iBTX-D
Pin# Top Connector
5
Data In (B)
Orange
6
CLK (B)
Blue
7
SCK (H)*
Red/Blk
8
Data (H)*
Wht/Blk
Pin # Bottom Connector
1
3.3V
Red
2
GND
White
3
N/C
4
Data Out (B) Black
iBTHX-W / iBTX-W DB9
Pin# Signal
Pin#
Signal
1
Data Out (B)
6
Data In (B)
2
N/C
7
CLK (B)
3
N/C
8
SCK (H)*
4
Data (H)*
9
3.3 Vdc
5
GND
B = Barometric Pressure
*H = Humidity
7
