![background image](http://html1.mh-extra.com/html/omega/flr-1000/flr-1000_user-manual_4124574008.webp)
pg. 8 of 33
Mounting The Sensor
(mounting hardware not included with sensor)
3.
Tubing Connections
CAUTION: DO NOT FLOW ANY GAS THROUGH A LIQUID
FLOW SENSOR OR FLOW METER. THIS WILL DAMAGE
THE MICRO-TURBINE ASSEMBLY AND VOID THE
WARRANTY.
All tubing must be clean and without crimps, burrs or scratches.
Only use the fittings factory installed on the unit. If the fittings are
removed the calibration of the unit may be effected and leaking may
occur. If different fittings are required please contact the Omega
Engineering Service Department for assistance.
When connecting the sensor to the tubing a wrench should be used to
stop the fitting rotating in the sensor body. Take care not to over tighten
the fittings or leaking may occur.
Connecting and tightening the Fittings
(FLR 1000-ST-D shown, other models similar)
Caution: DO NOT over tighten the fittings into the
sensor body. Excessive force may damage the sensor
body and will NOT be repaired under warranty.
Summary of Contents for FLR 1000
