Omega DP400TP, User Manual, Page: 31 / 60

User manual - DP400S - 31
11 Error messages
The instrument signals failures/anomalies by means of messages on the display.
The following are the possible messages:
Probe error
Detected a fault in the load cell or on the Melt sensor.
The control on sensor is executed at each device starting.
Read EEPROM failure Error during EEPROM memory reading
Write EEPROM fail
Error during EEPROM memory writing
Wrong tarature data Error on device calibration data
Wrong parameters
Error on device configuration parameters
Wrong status data Error on device status data
Param. out of range Detected a parameter value out of range.
Missing calibration
Error on device calibration data
In all of these situations, the instrument might not be able to operate correctly.
Switch it off and back on. If the problem persists, contact assistance.
12 Configuration
12.1 Modifying configuration parameters
For configuration parameters see paragraph 11
Press Display Do
1 “Configuration”
Shows 0000 with the 1st
digit selected.
2 “
n
” and “
m
”
Changes the selected digit
and moves to the next one
using “

”
Enter password 1234
3 “Sel” to confirm
Shows the names of the
parameter groups.
4 “
n
” and “
m
”
Scroll up / down the
parameter groups.
5
“Sel” to enter
the parameter
group
Shows the parameters of
the selected group. “
n
” and “
m
” to select
parameter to be modified.