Omega CN1001-TC, User Manual, Page: 32 / 48

SECTION 20. LOCK OUT CONFIGURATION (LK.CF)
Use Lock Out Configuration ( LK.CF ) for the following:
* To enable or disable the RESET button in the run mode.
* To enable or disable setpoint changes
20.1 To Enable or Disable the RESET button in the Run Mode
1. Press the MENU button until the meter shows “LK.CF” after ( “C.J.OF” ).
2. Press the / DEV button until the meter shows “RS.=E” (Factory default) .
3. Press the / MAX button to toggle between:
“RS.=E” To enable the RESET button in the run mode (Factory default).
“RS.=D” To disable the RESET button in the run mode.
4. Once desired mode shows, press the MENU button to store the change. The meter
returns to the run mode.
20.2 To Enable or Disable Setpoint Changes
1. Press the MENU button until the meter shows “LK.CF” (after “C.J.OF” ).
2. Press the / DEV button until the meter shows “ SP.=E” (Factory default).
3. Press the / MAX button to toggle between:
“SP.=E” To enable setpoint changes (Factory default).
“SP.=D” To disable setpoint changes
4. Once desired mode shows, press the MENU button to store the change.
20.3 To Enable Display’s Program Version:
1. Press the MENU button until the meter shows “LK.CF” (after “C.J.OF” ).
2. Press the / DEV button until the meter shows one of the following:
* “L.3=0” “SETPTS” button will display setpoint values.
* “L.3=1” “SETPTS” button will display “V.-03” which is the meter's current software
version.
3. Press the / MAX button to toggle between the choices above.
4. Press the MENU button to store the changes.
If your meter does not have the relay option, setpoint menu items above will not be
available and
SETPTS button will always display the meter's software version. These
units will have +OL (overload) or +OPEN memory indicated by Alarm 1 & 2 LED
displays. LEDs can be reset by pressing MENU then RESET button or by power OFF
then ON . These units can not use analog output proportional to error from setpoint 1.
under menu OT.CF, 0.3=P.
28