SECTION 18. OUTPUT SCALE AND OFFSET (OT.S.O) (Continued)
9.
Press the
/
DEV
button to scroll to the next digit.
10. Press the
MENU
button to store your selection. The display shows
“RD 2”
(Read 2).
This is your second point of display reading.
11. Press the
/
DEV
button. The last previously stored 4-digit number (-1999 through 9999)
displays with flashing 4th digit.
12. Press the
/
MAX
button to change the value of the flashing digit.
If you continue to press the
/MAX
button, the flashing digit's value continues to
change.
13. Press the
/
DEV
button to scroll to the next digit.
14. Press the
MENU
button to store your selection.
“OUT.2”
(Output 2) displays.
This analog signal should correspond to your Read 2 display.
15. Press the
/
DEV
button. Selected output displays.
If you select
“O.2=V”
for voltage, the maximum signal you may select is 10.00 for
an 0-10 V dc signal output. If you select
“O.2=C”
for current, the maximum signal
you may select is 20.00 for a 0-20 or 4-20 mA dc signal output.
16. Press the
/
MAX
button to change the value of the flashing digit. If you continue to press the
/
MAX
button, the flashing digit's value continues to change.
17. Press the
/
DEV
button to scroll to the next digit.
18. Press the
MENU
button to store your selection. The meter momentarily shows
“STRD”
,
followed also momentarily by
“RST”
(Hard Reset).
“CJ.OF”
(Cold Junction Offset) then
displays.
WARNING:
If the meter displays all flashing values on any item, the value has
overflowed. Press
the
/
MAX
button to start new values.
26
Summary of Contents for CN1001-TC
Page 46: ...42 NOTES...