SECTION 12. SETPOINT 2 CONFIGURATION (S2.CF)
Setpoint 2 Configuration (S2.CF) is not active unless your meter has dual relay output
capabilities. The LED's will display whether the (S2.CF) is active or not. You may use Setpoint 2
Configuration (S2.CF) for the following:
*
To set the setpoint's active band above or below your chosen value
*
To select whether the setpoint operation is latched or unlatched
1.
Press the
MENU
button until the meter shows
“S2.CF”
.
2.
Press the
/
DEV
button. The meter shows one of the following:
*
“S.1=A” (Active above the setpoint) (Factory default)
*
“S.1=B” (Active below the setpoint)
3.
Press the
/
MAX
button to toggle between choices.
4.
Press the
/
DEV
button again. The meter shows one of the following:
*
“S.2=L”
Setpoint 1 to be latched
*
“S.2=U”
Setpoint 1 to be unlatched (Factory default)
5.
Press the
/
MAX
button to toggle between choices.
6.
Press the
MENU
button to store your choices(s). The meter momentarily shows
“STRD”
,
followed by
“S1.DB”
(Setpoint 1 Deadband) or
“TIME”
(Cycle Time).
SECTION 13A. SETPOINT 1 DEADBAND (S1.DB)
Setpoint 1 Deadband (S1.DB) is not active unless your meter has dual relay output capabilities.
The LED's will display whether the (S1.DB) is active or not. If you have selected
“S.3-0”
in
setpoint 1 configuration (
“S1.CF”
- refer to Section 11) you may set the deadband (hysteresis) of
Setpoint 1; follow these steps:
1.
Press the
MENU
button until the meter shows
“S1.DB”
.
2.
Press the
/
DEV
button. The meter shows the last previously stored 4-digit number
(0000 through 9999) with flashing 4th digit.
3.
Press the
/
MAX
button to change the value of the flashing digit. If you continue to
press the
/
MAX
button, the flashing digit's value continues to change.
4.
Press the
/
DEV
button to scroll to the next digit.
5.
Press the
MENU
button to store value. The meter momentarily shows
“STRD”
, followed
by
“S2.DB”
(Setpoint 2 Deadband)
19
Summary of Contents for CN1001-TC
Page 46: ...42 NOTES...