BEFORE USE
1. Inspect before each use. Do not use if bent,
broken, leaking or cracked components are
noted. Ensure that casters, rollers and lift arm
moves freely. Check and tighten any loose as-
semblies.
2. Verify that the product and the application are
compatible, if in doubt call Omega Technical
Service (888)332-6419.
3. Read, understand and follow vehicle
manufacturer’s recommended tire change
procedures.
4. With jack in fully lowered position, locate and
remove oil filler plug. This purges the hydraulic
system of pressurized air trapped in reservoir.
Check fluid level. Proper level is even with filler
plug hole.
5. Reinstall oil filler plug.
HOW TO USE
1. Set emergency brake, chock tires of diago-
nally opposed wheel(s) in both directions AND
take every precaution necessary to ensure
setup is stable and prevent inadvertent vehicle
movement.
2. When tire & wheel assembly are ready to
remove, position wheel dolly to accept tire &
wheel assembly and adjust the length of chain
provided to secure load.
ASSEMBLY
Refer to Figure 2
1. Attach leg assemblies (ref. no. 2) to main
frame (ref. no. 1) using M12x1.75x70L &
M12x1.75x120L bolts, M12x1.75 nuts &
M12x3t washers (ref. nos. 3, 15, 4 & 5).
2. Install caps (ref. no. 17) to cover the holes on
the main frame (ref. no. 1).
3. Loosen all four of the M12x1.75x70L bolts (ref.
no. 8) and tighten the M10x1.5x60L bolts (ref.
no. 11) to expand the roller insert hole.
Note: Do not overtighten the bolts (ref. no. 11).
Adjust bolt’s tightness until it is expanded
enough for accepting the roller (ref. no. 6).
4. Slide roller (ref. no. 6) into the roller insert hole
on frame (ref. no. 7) until it is aligned with the
edge of the hole.
5. Loosen the M10x1.5x60L bolts (ref. no. 11)
and tighten all the M12x1.75x70L bolts (ref.
no. 8) to secure the roller onto the frame.
6. Attach the frame (ref. no 7) to main frame (ref.
no. 1) using the pin, c-clip and roller. (ref. no.
12, 13 & 14).
7. Install hydraulic unit (ref. no. 18) in between
the frame and main frame (ref. no. 7 & 1).
8. Attach hooks (ref. no. 21) to chain (ref. no. 20).
9. Attach one end of hook (ref. no. 21) through
angle frame hole and attach another hook to
the other hole.
Figure 2- Assembly Drawing for Model 47050
3
47050-M0
Load Leveler
