10. Use and maintenance manual
B01.24 - B02.44
San Maurizio C.se - 16/12/2020
www.omcr.it
MAXIMUM CAPACITY LOAD
CONSTRUCTOR
EC MARK
PRODUCT CODE
WORK ORDER NUMBER
LIFTING PIN MARK
Before each lifting, handling or turnover check that the lifting brackets capacity load is in
compliance with the die weight; the maximum capacity load, the work order number, the
constructor label and the
EC conformity mark
are indelibly marked on the lifting pins and
over the lifting brackets (see
Pic.4
).
NOTE:
the work order numbers of lifting brackets and pins are not necessarily corresponding
WARNING
3.6
In case of lifting and handling, the lifting bracket capacity load should be at least
1/2
of the whole die weight.
(upper half-die + lower half-die).
Example: Die weight 25000 kg - minimum lifting bracket capacity load: 25000 / 2 = 12500 kg
In case of half-die overturning the lifting bracket capacity load should be at least
1/2
of the half-die weight.
Example: Half-die weight 16000 kg - minimum lifting bracket capacity load: 16000 / 2 = 8000 kg
Before each lifting, handling or overturning of the die, check that the chosen sling system
(rope/chain, hook, etc.) doesn’t present any defect or deformation to make it unsafe;
otherwise replace immediately the damaged parts
.
WARNING
3.7
8000 kg
B01.24.08000
Fig.4
