9
Maintenance
impeller should not be necessary for general day use.
TO OPEN THE REAR PLATE FOR CLEANING:
•
Using a screwdriver, carefully remove the 4 screws and washers from the rear of the appliance.
•
Remove the 2 screws holding the plastic housing that protects the impeller.
•
Rinse the appliance under a running tap to clean any food from the heating coil and impeller.
• Re-install the impeller housing and back plate.
DECALCIFICATION
After some time, the water you use will deposit calcium onto the coils, much in the same way as the element
in your kettle. When the coils become covered by calcium deposits, they need to be cleaned to keep them
efficient. To do this, you can either use 25% vinegar solution in water, or add a dedicated decalcifying agent,
such as CLR (Calcium, Lime, Rust remover) to your water bath, following the dilution instructions provided by
the manufacturer.
Set the temperature of your water bath to 25°C / 77°F and allow the appliance to run for around 30 minutes.