9
Maintenance
Troubleshooting
SAFE ACCESS TO THE TOOLS
The juice extractor can only be started if the feed channel (3) and bowl (1) are positioned correctly and the
cover (2) is locked in the lowered position. Removing the feed channel (3) or lifting the cover (2) results in the
machine stopping. Re-starting the juice extractor requires specific operation of the “On/Off” push button (9)
again. A cut in the mains power supply stops the machine.
MAINTENANCE
Before carrying out any work on the cold press juicer, it must in all cases be unplugged from the mains power
supply and wait 20 seconds for the capacitor of the electronic board to discharge.
SPARE PARTS
IMPORTANT:
The use of spare parts other than certified original Omcan parts is prohibited.
This machine requires no specific maintenance because the bearings are lubricated for life. If any intervention
is necessary to replace parts subject to wear, such as the sieve (13), the scrapers (15), the seals (16), (18),
(20), (21), the electrical or other components, please refer to the parts list (see the exploded view at the end of
this manual). For all spare part orders (see references in the exploded view at the end of the manual), state the
type, the machine serial number and the electrical specifications recorded under the machine.
SERVICING
Neither a hose nor a pressure hose should be used for cleaning.
• After use, clean the plunger (4), the feed channel (3), the bowl (1), the top screw (11), the bottom screw
(12), the sieve (13), the scrapers (15), the discharge cone (17), the seal (18), the ring (19) and the pulp
container (5) in clean water or with a dish washing detergent product designed for this purpose. Then rinse
and dry. Do not use abrasive products or materials to clean the basket assembly.
•
The base is to be cleaned with a soft damp sponge, then dried.
CAREFUL
For easier cleaning, do not leave food remains to dry on the parts in contact with the food and clean all these
parts of the machine immediately after the work is finished.
THE MACHINE WILL NOT START
• Check: the mains supply and the condition of the power supply cord.
• Check: the presence of the feed channel (3) and the locking of the cover (2) in the lowered position Fig.13.
Summary of Contents for Santos 65
