9
Installation
PREPARATION
Before beginning assembly of product, make sure all parts are present. If any part is missing or damaged, do
not attempt to assemble the product. Contact Omcan for replacement parts.
Estimated Assembly Time: 60 minutes.
Tools Required for Assembly (not included):
• Phillips screwdriver w/ medium blade.
• Leak Detection Solution.
ASSEMBLY INSTRUCTIONS
1. Assemble the wheel assembly to the bottom plate. Fix the wheel assembly to the bottom plate using 4pcs
bolt M6X10 and 4pcs flange nut M6.
Hardware Used:
- Wrench (x1).
- Bolt M6x10 (x4).
- M6 Flange nut (x4).
2. Insert the pins of the base to the holes of lower support, press to secure the pins. Using 4pcs screw M5x10
to secure the lower support and base. Insert the pins of the Control Box Assy to the holes of upper support,
press to secure the pins. Using 4pcs screw M5x10 to secure the upper support and Control Box Assy.
Hardware Used:
- Philips Screwdriver (x1).
- Screw M5x10 (x8).
3. Assemble block belt. Fix the block belt to the 2pcs of lower support behind the front door,using 2pcs screw
M5X10.
Hardware Used:
- Philips Screwdriver (x1).
- Screw M5x10 (x2).
4. Assemble the middle support. Insert the 4pcs upper support to the lower support. Secure them with 8pcs
screw 3/16”.
Hardware Used:
- Philips Screwdriver (x1).
- 3/16” Screw (x8).
5. Assemble the flame screen to the upper support. Secure the flame screen to the upper support using 8pcs
screw 3/16”.
Hardware Used:
- Philips Screwdriver (x1).
- 3/16” Screw (x8).
6. Assemble the reflector onto the flame screen. Screw the 3pcs stud on the flame screen, put 3pcs washer
6 onto the top of stud, then put the reflector onto the stud, secure them with 3 pcs washer 6 and 3pc swing
nut.
Hardware Used:
- Wing Nut (x3).
