7
Installation
- oven thermometer.
2. Cart.
Packed with cart;
- casters and bolt hardware.
3. Chimney
TOOLS REQUIRED FOR ASSEMBLY
•
Box cutter.
•
16mm open end wrench - stainless steel side handles.
•
14mm socket/ratchet and 13mm open end wrench – casters onto cart frame.
INSTALLATION INSTRUCTIONS
Your oven requires a minimum of assembly:
•
Start by carefully removing packaging from oven and cart using a box cutter. Be careful as to not scratch
any of the steel or stainless steel surfaces of the oven or cart. Assemble components on a moving pad or
card board, to prevent scratching parts.
• Remove metal plastic wrapped ties that hold the oven and firebox doors in place.
• Remove nylon inserts on the hinged area of the oven and firebox doors.
•
Remove the plastic tube support in the oven chamber and the box that will contain the chimney cap, oven
thermometer.
•
The stainless steel side handles are attached to the stainless steel oven shelf.
•
Install the stainless steel side handles using the brackets and bolts supplied. They attach to either side of
the oven body. Remove the bolt in the oven body and attach bracket and handle using a 17mm socket or
wrench.
•
Insert the thermometer into the hole provided directly above the oven chamber. From the inside of the
oven, affix the nut and washer, tighten until snug. Do not over tighten.
•
Remove carton attached to cart and assemble casters using a 14mm socket and a 13mm open end
wrench. Turn cart on it’s edge to facilitate caster installation. We suggest position- ing the two casters with
locking device on the long side of the cart and where you will position the front of the oven.
•
With casters installed, place cart onto casters and lock the two front wheels.
WARNING: IT IS RECOMMENDED THAT TWO OR MORE PEOPLE LIFT OVEN DUE TO ITS WEIGHT
• Set oven onto the stand. Remember the oven is heavy and will require assistance. The bottom of the oven
has tabs that are designed to slot into the inside of the cart frame. Make sure the oven is seated properly
on the cart frame.
• Pre-fit the chimney cap into the stainless steel chimney and install chimney and cap over the steel
extension on the top of the oven. It is designed to fit snugly, install by rotating the chimney downward.
