Omcan 45219, Instruction Manual, Page: 15 / 44

15
Installation
DETERGENT AND RINSE AID REGULATION.
I. Open the lower front cover (2 bolts).
II. Take out the feeders.
III. Adjust the quantity by regulating the dosing (xxxxxx ml / rotation).
IV. Replace the feeders.
V. Make sure that the chemical feeders’ hoses are not out of the right position.
VI. Replace the front lower cover.
RINSE-AID PUMP
This model has an automatic rinse-aid pump for use with a container of liquid rinse-aid. The rinse-aid pump is
a peristaltic regulated (looks exactly like the detergent pump) and can be regulated by a screw above and on
the right of the glass cover. The regulation can be from 0 lt/hour to 0,7 lt/hr.
Both pumps are mounting vertically on an inox bracket on the left of the booster and are marked with two
yellow stickers.
Before you perform these adjustments, turn off the power supply.
The dozer is adjusted from the manufacturer’s premises at its maximum value for easy initial priming
and must be adjusted accordingly (depending on water hardness, how dirty the dishes are, and the
detergent used).
To reduce (-) the amount of rinse aid, turn the center screw clockwise. To increase (+), turn counterclockwise.
Note: this is a 15 revolution adjusting screw to provide fine adjustments as required.
Suggestion for initializing personnel:
After priming system by operating machine through several cycles,
rotate adjusting screw gently to full closed position (clockwise) and adjust (counter-clockwise) about 7
full revolutions. Empty wash tank and refill with fresh water. Operate for two or three cycles and verify
concentration level. Adjust dozer again if required to achieve final desired results.
ADJUSTMENT OF PERISTALTIC PUMPS
PUMP REGULATION
DETERGENT RINSE
2.6ml/rotation 1.2ml/rotation