4
UTILIZZO
USE
17
OMCA S.r.l
-
Via Curiel, 6 - 42025 - Cavriago (RE) - ITALY
Phone:
+39 0522 943502 / +39 0522 943503 -
Website
: www.omcasrl.it -
9)
Premere il pulsante di marcia (
Fig.4.1 pos.E
) e ruotare lentamente
il potenziometro che regola la velocità di avanzamento (
Fig.4.1
pos.O
) fino alla posizione di
0.3
(
m/min
).
La macchina è pronta per partire quindi tenendo ben salda la
macchina con entrambe le mani premere i due pulsanti bimanuali
(
Fig.5 pos.g
). Durante la lavorazione tenere sempre la macchina
agganciata al paranco per maggiore sicurezza.
10)
In base alla dimensione dello smusso e del tipo di materiale è
possibile aumentare la velocità di avanzamento.
11)
Alla fine della lavorazione, prima che la macchina scenda con una
ruota di trascinamento diminuire la velocità di avanzamento fino
alla posizione di
0.3
(
m/min
).
12)
Per fermare la macchina premere il pulsante rosso di stop (
Fig.4.1
Pos.L
) del quadro generale.
9)
Push the start button (
Pic.4.1 pos.E
) and turn slowly the
potentiometer of feed speed regulation (
Pic.4.1 pos.O
) until the
position of
0.3
(
m/min
).
The machine is ready to start, by keeping well steady the machine
with two hands, push the two bi-manuals buttons (
Pic.5 pos. g
).
During the job, always keep the machine hooked to the tackle for
more safety.
10)
Based on the chamfer dimension and the type of material it is
possible to improve the feed speed.
11)
At the end of working, before the piece goes down from a feed
wheel, reduce the feed speed until the position of
0.3
(
m/min
).
12)
to stop the machine push the red button on the control board
(
Pic.4.1 Pos.L
).
Summary of Contents for 930
Page 26: ......