16
You selected IC7800 addr.6AH and
19200 Bd. Press
SET
to write to the
memory, then press
EXIT
to go back to
the SETTINGS possibilities.
“
SET OTHER ADDRESS
” means that
you must add here a new type of ICOM
TCVR which is not defined in the table
(its address plus bitrate in Bd) to allow
communications with it.
Press
ANTENNA SETTINGS
. First
select
ANTENNA SWITCH
(No switch,
Standard). Use left or right arrows. If you
select some switch, 10 ports for different
antennas displays. Generally all of
antennas are allowed in every band
(green squares). To disable some
square select port (up/down), touch
SET
for antenna name and then select band
(left/right). Press
SET
.
Four types of antennas for four different
bands were disabled.
Black
square
means
disabled
combination.
Press
EXIT
to go back to
SETTINGS
menu
BCD code (4 bits) is used for automatic antenna and BPF switching (see Antenna/BPF
connector on the Control panel (rear side of the PA). See section 7.9 for Control and
ANT/BPF connectors pin-out.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
