Buckle cam
groove
Boss
Buckle
E-14
:
• If the standard port is attached improperly to the case, water penetration
may result. Also make sure that the buckles on the left and right of the
standard port are clamped firmly. Confirm indications “OPEN” and
“LOCK” on the buckle when removing and reattaching the port.
CAUTION
Removing
Wipe off any water drops, making sure the case is
completely dry. Slowly rotate each of the two buckles on the
left and right of the standard port (from the bottom toward
the top as indicated by the arrow in the figure on the right).
When the two buckles have been turned by about
110 degrees, the standard port begins to
separate from the case.
Continue turning the buckles slowly until the
standard port separates completely from the
case.
Attaching
Align the cam grooves of the buckles on the left
and right of the standard port with the bosses on
the case.
Fit the bosses into the left and right buckles and
fit the standard port into the case while slowly
turning the buckles clockwise.
Turn the two buckles clockwise until they stop to
secure the standard port.
❈
For detailed handling of the separately available Wide Port for the PT-
020/PT-027 (PPO-02), refer to the Wide Port’s instruction manual.
Removing/attaching the standard port
When using the case with the separately available Wide Port for the PT-020/027
(PPO-02), the standard port attached to the PT-020 or PT-027 should be removed.
To remove or reattach, use the following procedures.
1
2
3
1
2
3
PT̲027EFDS̲E.qxd 2005.4.28 4:59 PM ページ E-14
