E-21
Insertion of silica gel
Before sealing the Case,
insert the accessory silica
gel bag (for prevention of
fogging) between the
bottom of the camera and
the Case. Insert the bag
with the glued longer side
to the inside.
:
• Insert the silica gel all the way at the specified location and
with the specified orientation. When the orientation is not
correct, the silica gel bag will be caught when the Case is
sealed and water leakage will be caused.
• Attempting to seal the Case with the bag inserted only part of
the way will cause the silica gel bag to get caught by the O-ring
and water leakage will occur.
• Once silica gel has been used, the moisture absorption
performance will be impaired. Always exchange the silica
gel when the Case is opened and closed.
CAUTION
Lifting the mode dial knob
While lifting the mode dial knob (on the rear lid of
the case) as far as it can go, close the rear lid
gently. When closing the rear lid, make sure that
the camera's mode dial does not touch the bottom
end of the case's mode dial knob.
Fitting the mode dial knob
After closing the rear lid of the case, press the
case's mode dial knob back down. Make sure that
the base of the case's mode dial knob sits properly
on the camera's mode dial.
At this time, operate the case’s power switch lever
to make sure that the camera’s switch lever can be
operated correctly.
Advice • After properly fitting the case's mode dial knob, turn the knob to
make sure that the camera's mode dial switches before closing the
case tightly.
Pay attention to the orientation.
PT̲027EFDS̲E.qxd 2005.4.28 4:59 PM ページ E-21
