Olympus OmniScan MX, User Manual

Page: 66 / 230

DMTA-20015-01EN [U8778402], Rev. M, February 2017
Chapter 3 54
Never spray liquid directly onto the acquisition modules. Liquid could seep into the
cracks or flow into the housing and damage circuits. Before cleaning the screen, make
sure that the rubber protectors are installed on the acquisition module.
3.3 Replacing the Touch-Screen Protector
This section explains how to replace the touch-screen protector.
To replace the touch-screen protector
1. Remove any dust or dirt on the touch screen (dust and dirt cause bubbles to
appear on the protective film). See “Screen and Screen Protector Cleaning” on
page 53.
2. Simply remove the label marked No. 1, and peel away the protective film on the
back.
Avoid touching the back of the screen protector after the protective film on the back is
peeled away. Doing so will leave a trace of your finger prints.
3. Align the protector into the correct position on the screen, and slowly install the
screen protector.
4. Remove the label marked No. 2, and peel away the film on the front. Provided
that there is no dust trapped underneath, all small bubbles will dissipate within
48 hours.
Dust particles can be blown away prior to installation using a can of compressed air.
CAUTION
NOTE
TIP