Olympus OmniScan MX, User Manual

Page: 65 / 230

DMTA-20015-01EN [U8778402], Rev. M, February 2017
Maintenance 53
Figure 3-1 Module with PA connector cap
3. Make sure that all external ports on the OmniScan MX2 have been covered with
their rubber protectors.
4. Make sure that the access doors are closed.
5. Place the cap on the scanner interface connector.
6. Make sure that the battery compartment door is closed correctly.
7. Make sure the left side panel is closed.
8. To restore the instrument’s original finish, clean the casing and module with a soft
cloth.
9. To remove persistent stains, use a damp cloth with a mild, soapy solution. Do not
use abrasive products or powerful solvents, which could damage the finish.
10. Once the connector protectors are removed, make sure the connectors are dry
before connecting anything to them. If they are wet, dry them with a soft, dry
cloth, or let them air dry.
3.2.2 Screen and Screen Protector Cleaning
Never use abrasive products or powerful solvents to clean the OmniScan MX2 touch
screen and screen protector. Clean the touch screen and screen protector using a
damp cloth moistened with a standard, evaporating glass cleaner. If necessary,
remove any paper-towel residue with a soft-bristle brush.
PA connector
cap