10-003591-01EN [Q7780031], Rev. 4, January 2020
Setup of Equipment
23
2. Setup of Equipment
The FlexoFORM scanner and the instrument must be properly connected and set up
to enable inspection.
2.1
Setting Up an Instrument Using a USB Key
You can load a predefined inspection-parameter setup from the supplied USB key
into your OmniScan instrument. Or, if the predefined setups are not suitable for your
requirements, you can create a new setup.
To set up an instrument using a USB key
Load the setup from the USB key:
a)
Use a computer to transfer the setup from the supplied USB key to the
OmniScan instrument’s SDHC memory card.
b)
Insert the SDHC card into the OmniScan and then turn it on.
c)
Select the setup.
2.2
Setting Up an Instrument Using the Interface
Most common setups can be easily created by following the instructions in the
User’s
Manual
for your OmniScan instrument. The instructions below are specific to the
FlexoFORM scanner, and should not be considered complete.
Summary of Contents for FlexoFORM
