12
1
EN
In
ser
tin
g t
he
b
at
teri
es
1
2
3
Inserting the batteries
This recorder can be used with either AAA Ni-MH
rechargeable batteries or AAA alkaline batteries. Do
not use any other type of battery.
1
Lightly press down on the battery cover
release button, then open the battery
cover, as shown in the illustration below.
2
Insert two AAA batteries observing the
correct polarity, then close the battery
cover.
• Insert the batteries in the direction marked
inside the battery compartment. When
inserting the batteries, note that the battery
removal tape is under the batteries as shown
in the illustration.
• The supplied Ni-MH rechargeable batteries are
not fully charged. It is recommended to fully
charge them before using the recorder for the
first time or after the batteries have been left
unattended for a long time (
☞
P.13).
Battery indicator
The battery indicator on the display will decrease as
the battery loses power.
SCAN
EXIT
Battery
Ni-MH
Alkaline
Selecting battery type
When the recorder is turned on after inserting
or replacing the batteries, the battery type
selection screen is displayed. On this screen,
select [
Ni-MH
] or [
Alkaline
] according to the
type of batteries used. The voltage detection
method optimized for the selected battery
type is set.
• When [
] indicator appears on the display,
charge or replace the batteries as soon as
possible. When the battery is too weak, [
] and
[
Battery Low
] will appear on the display and the
recorder will shut down.
Replacing the batteries
1
Lightly press down on the battery cover
release button, then open the battery
cover.
2
Pull up the removal tape to remove old
batteries.
• When pulling up the tape, the batteries may
suddenly pop out. Be sure to press down lightly
on the batteries with your finger while pulling up
the tape.
3
Insert new batteries.
