182
Chapter 11
Troubleshooting (Cont.)
POSSIBLE CAUSES
CORRECTIVE ACTION
REF. PAGE
No picture is taken when the shutter button is pressed.
1
The mode dial is set to
.
2
The memory gauge is
full.
3
The flash has not
finished charging.
4
The card access lamp
blinks after shooting in
the mode.
5
There is a problem with
the card.
6
The card is full.
7
The batteries ran out of
power.
8
The monitor indications
disappear, or only the
battery check lights up.
9
A write-protect
adhesive seal is placed
on the card or there is
no card in the camera.
1
Set the mode dial to any
position except
.
2
Wait until there is room in
the memory gauge.
3
Remove your finger from the
shutter button and wait until
the orange lamp stops
blinking. Take your shot
again.
4
The recorded movie image
data is being written to the
card. You can start shooting
again when the card access
lamp stops blinking.
5
See the error code chart.
6
Erase unwanted pictures or
insert a new card. Before
erasing, download important
images to a PC.
7
Replace the batteries with
new ones.
8
Replace the batteries with
new ones. (Do not open the
battery compartment cover
when the card access lamp
is blinking.)
9
Insert a new card in the
camera.
P. 47
P. 16
P. 78
P. 72
P. 189
P. 137
P.19
P. 19
P. 24
