9
Operation
Assemble the metal bracket enclosed for cooling the bound folders.
Connect the power cable to an easily accessible, standard electrical socket.
Caution:
Check that the voltage specifications of the unit correspond
to that of your power supply network (220-240 V, 50/60 Hz).
1
Switch on the On/Off switch on the right-hand side of the unit
(Position "I").
2
Wait until the yellow indicator lamp (Ready) lights up and an acoustic
signal is issued. The warm-up phase requires approx. 3 minutes.
3
Use the folder width switch to set the required width. (on the left-hand
side of the unit).
COUNTER time for < 16 mm = 80 seconds // >16 mm = 120 seconds
4
Insert the paper in the corresponding folder.
5
Insert the folder in the COUNTER slot with the closed side at the bot-
tom. The integrated clamping mechanism holds the paper perpendicu-
lar.
6
Press the COUNTER button; the green LED flashes.
7
When COUNTER has been completed successfully, an acoustic sig-
nal is issued and the green LED stops flashing.
8
Remove the folder and place it in the cooling device for 10 minutes.
Too short a cooling phase will result in sheets being loose.
9
Repeat steps 3-8 to bind more folders.
Caution:
The spine of the folder just bound is very hot.
Overheating Protection with Auto Off Feature
1
The unit is equipped with an Auto Off feature to protect folders, which
have not been removed, from overheating.
2
When the COUNTER process is finished, an acoustic signal is issued
and, at the same time, the Auto Off feature is activated.
3
If the COUNTER button is not pressed again within approx.10 min-
utes, the power supply is electronically switched off to prevent over-
heating.
4
To start COUNTER again, the unit must be switched off and on again.
