922502050
_0
9
_00
8
These luminaries are used indoors
o
(
ta 40 C
)
on the wall, where
emergency light is needed.
Each
luminary must be permanently
connected to mains power supply
.
In normal operation the battery is
charging.
In case of a mains power
supply failure the luminary will
light the led strip automatically in
emergency mode.
When the mains
power supply is restored the device
turns to normal operation.
Non Maintained / maintained
operation
there is an option to
select the non maintained or
maintained operation by placing
the jumper to the appropriate
position according to figure 4 (see
page 3)
.
Installation
T
y
o install the luminar follow the
installation instructions on pages
2
and 3.
ΑΤΤΕΝΤΙΟΝ
!!!
1. Operations for installation,
maintainance or testing must be
done by authorized personnel only
.
2.
The device must be connected
to the mains power supply through
a fuse dependent by the total
amount of the line’s power load
.
3.
It is suggested to check every
month the indication LED for
battery charging, and by pushing
the TEST button to check the
emergency circuit. The led strip
should light as long as the TEST
b u t t o n i s p r e s s e d a n d t h e
indication LED for battery charging
should be off.
If the luminary
doesn’t work as described above
contact the installer.
4.
It is suggested to check every 6
months the minimum autononous
duration by disconnecting the
mains power supply
.
Count the
time that the led strip lights and in
case of less time than the nominal
autonomy, the battery must be
replaced. If the measured time is
considerably less than the nominal
autonomy
In
contact the installer.
case of battery replacement, this
must be replaced by part of the
same type,
by the manufacturer or
by a competent person.
5.
In case of inactive use for a
period greater than 2 months,
disconnect the battery by pulling
out the battery’s connector.
6
.
I
s not allowed to discard
t i
batteries in to common
trash bins, they must be
discarded only
in battery
recycling points.
Do not
incinerate.
Test Button- Manual Test for
emergency operation
The manual test can be conducted
only if the mains power supply and
the battery is connected
:
After 3 seconds, the luminary
returns to normal operation.
Indication LED status
Charge
On:
Fully charged.
Off:
No battery (No charging
current or disconnected battery).
Blink:
Charging.
1
1
1
1
Luminaire
Wall mounting accessorie
Ceiling mounting accessorie
Manual
Package contents
Γενικά
1
922502050
_0
9
_00
8
2
922502050
_0
9
_00
8
Installation methods
Wall mounting
Luminary disassembly
Luminary
assembly
3
Battery replacement
4
3
5
2
1
Ενδεικτικά
1
2
N
L
Insert the
power cable
Insert the
power cable
Insert the
power cable
Insert the
power cable
1.
Disassemble the luminary
.
2.
Remove the battery connector and carefully remove the battery from its base
.
3.
Install a new battery of the same type and rating
.
4.
Assemble the luminary and power the device
.
Α-2130
:
Accessorie for ceiling
(
1m)
Α-2131
:
Accessorie for ceiling (0,5m)
Α-2132
:
Accessorie for ceiling (0,25m)
Α-2133
: Accessorie for wall mounting
Α-2136
: Accessorie for hanging installation
(2,5m)
A-2520/PL
:
Suspended ceiling base
>5mm
General
Insert the
cable grommet
Hanging installation
After the desired installation follow the steps below
Ceiling mounting
Maintained
(default)
Non
maintained
Battery
connection
Accessories for installation
(After request)
Insert the
cable grommet
Insert the
cable grommet
Insert the
power cable
