olympia electronics BS-468/A, Quick Installation Manual

Page: 23 / 28

Page 23 921468007_90_005
10. COMMON FAULT INDICATIONS
Fault Cause and Solution
"PANEL, OVERCHARGE"
Problem with the panel's battery. Contact
your technician.
"PANEL, UNDERCHARGE"
Problem with the panel's battery. Contact
your technician.
"PANEL, DISCONNECTED BATTERY"
Check the battery cable connections. If the
problem persists, contact your technician.
"PANEL, NO AC"
Check the power supply connections of the
panel. Check the mains supply for proper
voltage. If the problem persists, contact your
technician.
"PANEL, DATE-TIME NOT SET"
The panel's time/date is not set. Set the time
from the keypad's menu or the PC software.
"EXTENSION, NO CONNECTED UNIT"
There was an extension card installed and it
has now been removed or is not working.
Check the card's connection with the panel.
If the error does not disappear in a few
minutes, contact your technician.
"EXTENSION, NO CONNECTED UNIT"
A new extension has been connected and is
not registered. Select the "SYSTEM, SCAN
EXTENSIONS" menu from the technician
menu.
"ZONE xx, DEVICE COMM TIMEOUT"
An installed wireless device on zone xx is no
longer communicating with the panel. Check
the battery of the device. Ensure that the
device is within the range of the panel. If the
problem persists, contact your technician.
"ZONE xx, RF SLAVE LOW BATTERY"
The battery level of the wireless device
belonging to zone xx is low. Replace the
device's battery.
"ZONE xx, RF SLAVE POOR SIGNAL"
The signal level of the wireless device
belonging to zone xx is low. Change the
device position and get it closer to the panel.