Olymp GOsafe 5300 Series, Operating Instructions Manual

Page: 13 / 44

12
ATTENTION: A maximum of 100 fingerprints are supported!
Please use the same finger when registering fingerprints!
To improve the rate of correct finger identification, you can follow the advice below:
We recommend that each user register 2-3 fingerprints.
We recommend women and children to register with thumb and middle finger.
Try to press with even force.
In very dry weather, we recommend breathing on the fingers until they are a little wet.
Alarm -
Wrong code
If 5 consecutive incorrect code entries or 5 consecutive incorrect fingerprint (only for 5300FP series) entries are
made, a warning tone sounds for 30 seconds. In the meantime, both the keypad and the fingerprint scanner (only for
5300FP series) are locked for 210 seconds.
Alarm -
Shake alarm
• Press "0" while the unit is in sleep mode.
• Then the vibration alarm system is activated.
• You can stop the alarm by entering a password or fingerprint (only for 5300FP series).
Restoring the factory settings
• Open the safe.
• Press the reset button for 3-4 seconds.
• You will hear two beeps.
• The safe is reset to the factory settings.
In the factory settings, the user code is "1234" and the master code is "123456" and each fingerprint (only for
5300FP series) allows the safe to be opened.
ATTENTION: In the factory settings. The user code is "159" and no fingerprint (only for 5300FP series) allows the
safe to be opened!
Turning the sound off/on
The key tone can be switched off and on by pressing the "CLEAR" key while the safe is in sleep mode (the display is
off). The display shows "SOUND ON" or "SOUND OF".