1.
Screw in offset connectors (18) to water feed sections
ending with female thread G1/2, sealing the connection
with an appropriate amount of teflon tape or thread.
After the installation, the axes of openings in the offset
connectors (from the tap side) must be at the same
height, their face surfaces at the same distance from the
wall, and the spacing of the openings equal to the
distance between axes of connection nuts of the tap
body.
Water feed connections must be installed so that cold
water is fed to the right side of the tap and hot water to
the left side (looking from the front of the tap) and so that
axes of connections are perpendicular to the wall and in
parallel to each other.
2.
Screw or put rosettes onto the offset connec
-
tors.
Place seals (16) in connection nuts (15) and screw
them on the offset connectors of the tap (18).
Next, set them from the bottom of the tap body
with two Allen head screws.
After installation, check connections to ensure
there are no leaks
Note!
The drawings are for illustration and instruction purpose only.
The appearance of the tap may be different from that seen in the drawings
