Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 6
3.
Position
1C - Floor Runners
on completed floor frame so runners are
flush but not overhanging. Attach with
4 - 2 1/2” Screws
per runner. There
are 7 floor runners in total.
Parts (Steps 3 - 4)
1C - Floor Runners
(1 1/2” x 3 1/2” x 45 1/2”)
x 7
Hardware (Steps 3 - 4)
S1 - 2 1/2” Screws
x 28 total
4.
Complete remaining floor runners as shown above. With Floor Runners attached, carefully flip the floor
over and place on your foundation.
Caution -
Be careful when laying floor down not to bend or twist floor.
Note:
Having a level foundation is critical. Choosing a foundation will vary between regions. Typical
foundations can be concrete pads or patio stones positioned underneath the floor runners.
Concrete Slab
Foundation
5.
Position
1D - Plywood Floor
on top of completed floor frames.
Plywood will sit slightly inset from outside of floor frame.
Parts
1D - Plywood Floor
(5/8” x 45 3/8” x 70 5/8”)
x 2
Note:
Plywood is cut slightly
smaller than floor framing.
Keep plywood seams tight.