71.
After all Roof Panel Sections have been positioned,
slight adjustments to some of panels may be necessary to
get the best fit. When correctly positioned, secure with 4
additional 3” screws per panel as shown above. Reach
through Skybox while securing Roof Panels at the top.
Remember, gaps between Roof Panel Sections will be
covered later by Roof Ridge Caps.
72.
Locate 1” x 4 1/2” x 54 5/8” long
Facia Boards. Facia Boards are angle
cut on each end. Place 1 board over
the entrance way underneath the roof
and against the rafter ends.
Facia Board should be positioned
flush underneath the roof panel
and angle cut end of board
should sit approximately halfway
on Rafter end.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 26
