30
Heater assembly
•
Open the heater (Fig.8):
1. Remove the plastic covering cap and the
screws from the right and left side panels.
2. Lift the top panel (A) approx. 10mm.
3. Pull the top panel forwards.
4. Lift off the top panel.
5. Pull the rear top panel (B) forwards.
6. Lift off the rear top panel.
•
Hang the heater onto the wall-mounting brackets
(Fig.9):
Depending on the type of mounting chosen, place
the heater runners either on the floor supports or
directly on the floor itself and push it up to the wall-
mounting brackets.
7. Pull the internal part of the right-hand wall
bracket (C) upwards and hold it.
8. Slide the heater with the fixing hooks on the
rear panel through the opening in the wall-
mounting bracket.
9. Let the internal part of the right hand wall
bracket slip downwards and slide it down until
it stops. The heater is then fixed against tilt-
ing.
10. Repeat steps 7 to 9 for the left hand wall
bracket.
•
Only for heaters 14/566, 14/567, 14/568:
Remove the holding bracket (Fig.10):
Remove the holding bracket by simultaneously
pushing together the front and rear panels of the
internal heater cabinet towards the middle.
Caution:
The holding bracket is a functioning part
of the heater and must be replaced later.
•
Remove the front panel (Fig.10):
Caution:
Before removing the front panel of
heaters with integral room thermo-
stats, first remove the cables from the
rocker switch on the operating panel.
The right hand side panel must first be
removed.
11. Remove the top left and right screws from the
front panel (D).
12. Tilt the front panel forwards approx. 30mm.
13. Remove the front panel upwards.
Caution:
Take care not to bend the flaps on the
underside of the front panel!
Fig.8 Open the heater
Fig.9 Hang the heater into the wall brackets
Fig.10 Remove the front panel
2.
4.
6.
3.
1.
5.
A
B
8.
7.
9.
10.
C
12.
13.
11.
11.
D
Summary of Contents for 14563
Page 14: ...14 Schaltplan 3 78 4514 5631...
Page 80: ...80 Schakelschema 3 78 4514 5631...
Page 90: ...90...
Page 91: ...91...