28
Floor mounting
When floor mounting the heater, break off the wall-
mounting brackets at the required position by bending
them back and forward. Only the top part of the
bracket is to be used to prevent tilting.
Fix the shortened wall-mounting brackets to the wall
(using 2 screws per bracket) with a clearance of „
H
“
and a tolerance of max. ± 10mm (Fig.4, table 2) using
the materials supplied or other, more suitable materi-
als (mounting holes in the brackets are of 10mm di-
ameter). The clearances to be adhered to are found in
the chapter „minimum clearances“.
The wall surface on which the brackets sit should be
even. If this is not the case, suitable underlay material
must be used.
Fig.4 Tilting prevention bracket / heater
Heater Dim.
H
14/563 236
14/564 412
14/565 588
14/566 764
14/567 940
14/568 1116
Table 2
Heater width – see „Technical Data“
H
eater
h
e
ig
h
t 540
Summary of Contents for 14563
Page 14: ...14 Schaltplan 3 78 4514 5631...
Page 80: ...80 Schakelschema 3 78 4514 5631...
Page 90: ...90...
Page 91: ...91...
