Enhanced 10/100Base-TX to 100Base-FX Converter
NWay DIP Switch Setting
Use the NWay DIP switch to activate NWay
operations.
Factory NWay DIP switch default set to ON position.
Check that the networking device to be connected to
the Converter has NWay support.
If
YES
: Check that the NWay DIP switch is set to the
ON position. The Converter will automatically
set the optimum speed and duplex mode on
the copper segment. Users can skip the
settings for DIP switches 2 and 3, when NWay
is activated.
If
NO
: Set the NWay DIP switch to the OFF position.
Then Use
DIP
switch 2
to manually select
between half (HD) and full duplex (FD) modes.
Use
DIP
switch 3
to manually select between
10Mbps or 100Mbps speeds. Set NWay
switch to OFF position when connecting to an
auto-sensing device that only supports
10/100Mbps detection. Some early switch
models only support auto-sensing of speed,
and NOT auto detection of speed and duplex
mode (auto-negotiation).
Important
In order to configure DIP switches 2 (duplex
mode) and 3 (speed), you must set DIP
switch 1 (NWay) to the OFF position
- 10 -
