36
Figure 6.19:
Deck Shake Timer
For example, if the deck should start out on for 2 seconds, then off for 10 seconds, and
repeat this cycle for the entire batch cycle of 30 seconds, then Figure 6.20 illustrates the
settings that would need to be input into the appropriate grey input boxes.
Figure 6.20:
Deck Shake Timer Example for 2 seconds on, 10 seconds off, repeated through a
30 second batch cycle
Note: The deck shake timer setpoint cannot be altered while a batch is
running. The timer will not reload the new setting until the current batch is
stopped and a new one started.
6.2.4
Current Timer Readouts
The Control Panel screen, in Batch Mode, also has a readout for the time remaining for
each of the timers set above. It displays the remaining time in minutes: seconds. For
the example shown in Figure 6.20, the time remaining panel would look like Figure 6.21
before the machine is started.
