Oliver 6510, Owner'S Manual

Page: 20 / 38

5. MAINTENANCE 5-1
This machine is designed and manufactured for easy operation and maintenance.
Design technical solutions, materials used, protective coatings, were planned to reduce
maintenance requirements.
Nevertheless we recommend performing a set of tasks with the aim to grant
machine safety, reliability and efficiency in the long run.
5.1. ROUTINE MAINTENANCE
The machine must be performed daily at the end of utilization.
)
Clean machine bed with compressed air.
)
Verify status of electric power cord, which should not show cuts or abrasion.
)
Check mill cutters wear.
)
Verify debris level in pneumatic system filter collection tank.
5.2. PERIODIC MAINTENANCE
To be carried out weekly.
)
Verify safety of electrical installation: electrical insulation, working conditions of
differential safety circuit breaker, continuity of protection cable.
)
Check proper locking of all mechanical elements of machinery.
)
Periodically lubricate and oil all joints subject to seizure, particularly the cams
plates and the sliding bar of the mill cutter unit.
)
Lubricate bearings on mill spindle.
5.3. LIST OF RECOMMENDED LUBRICANTS
Reduction gear MOBIL GEAR 632
Cams MOBIL VACTRA No. 2 Oil
Spindle bearings KLUBER ISOFLEX LDS 18 SPECIAL A Grease
Ball bushings MOBIL Mobilux No. 2 Oil
F.R.L MOBIL D.T.E Oil Medium