HP-400P HORIZONTAL BAND RESAW -35-
2. Slide the upper guide block up, place a dollar bill underneath the upper guide block, then let the upper
guide block slide down to sandwich the dollar between the blade and the upper guide block.
Dollar bill upper guide block and blade.
3. Keep the dollar bill in place and tighten the upper guide block.
4. Remove the dollar bill.
5. Repeat steps 1-4 with the blade guide on the other side of the conveyor.
Support Bearing
The support bearing is positioned behind the blade to brace it from pushing backwards during a cut. Please
see below, the support bearing components to clarify the adjustment instruction.
Support bearing components.
To adjust the Support Bearings
：
1. Loosen the lock bolt approximately 1/4 turn.
Note—If you loosen the lock bolt too much, the support bearing will fall out of place.
2. Turn the adjustment shaft until the support bearing is positioned approximately 0.016" behind the back of
the blade. Use a feeler gauge or four thicknesses of a dollar bill to check this.
3. Tighten the lock bolt, and repeat with the other support bearing.
4. Test the adjustment of the support bearings by spinning the wheels by hand, at full blade tension, in the
same direction of operation. While you are spinning the wheels, the support bearings should not turn. (The
support bearings should only turn during cutting operations.)
