FIG. 17
FIG. 20
E.
ROLLING STAND
Use the tools in the stand hardware bag
as shown in
FIG. 17
,
□
C
Flat Wrench
and
□
D
Hex Wrench for the installation.
STEP 1:
Insert the storage foot to the
stand axle, and place and tighten the
□
B
screws x 2 to secure storage foot as
shown in
FIG. 18
.
STEP 2:
Attach
□
F
nuts x 2, and
□
H
washers x 2 and
□
E
wheels x 2 to the
stand axle as shown in
FIG. 18
.
F.
SECURE SAW ON STAND
STEP 1:
Press the leg release button to
unfold the stand legs as shown in
FIG. 19.
STEP 2:
Place the table saw unit on the
stand. Attach and secure the table saw
unit to the stand with
□
A
screws x 4,
□
F
nuts x 4 and
□
H
washer x 4 on both
sides on the stand.
FIG. 19
shows the
front side.
G.
CONNECT A DUST
COLLECTION
STEP 1:
Attached a 2
½
” dust hose (not
included) to the dust port as shown in
FIG. 20
.
STEP 2:
Secure the hose
with a hose clamp.
Make sure the hose
is attached to the
dust port tightly.
Handle
Storage
Foot
FIG. 18
Leg Release
Button
FIG. 19
Oliver 10010 10" Job Site Saw Owner's Manual
19