2. Safety
2.1 Instrument Safety
The system should be serviced by authorized personnel only.
For complete instrument safety information, including a full list of the symbols on the instrument, refer to the Olink®
Signature Q100 User Manual (1172).
WARNING:
PHYSICAL INJURY HAZARD. 2-person lift. Use proper lifting techniques.
The instrument weighs approximately 41.5 kg (91.5 lb). If you choose to lift or move the
instrument after it has been installed, do not attempt to do so without the assistance
of at least one more person. Use appropriate moving equipment and proper lifting
techniques to minimize the risk of physical injury. Follow local ergonomic directives and
regulations.
Also make sure to not plug it until all top, side and back panels are in their closed
positions.
WARNING:
Do not tilt or tip the Olink® Signature Q100 system as it may damage the
hardware and electronics of the instrument.
AUTION:
C
Removing the enclosure creates a potential shock hazard from exposed
internal components. Ensure the instrument is unplugged from the power source before
removing the Z optics lock.
AUTION:
C
PINCH HAZARD. The instrument door and tray can pinch your hand. Make
sure your fingers, hands, and shirtsleeves are clear of the door and tray when loading or
ejecting a chip.
2.2 Electrical Safety
NOTE:
The main power switch is on the rear panel of the instrument.
ELECTRICAL HAZARD:
Plug the system into a properly grounded receptacle with
adequate current capacity.
2.3 Chemical Safety
The responsible individuals must take the necessary precautions to ensure that the surrounding workplace is safe and that
the system operator is not exposed to hazardous levels of toxic substances. When working with any chemicals, refer to the
manufacturer or supplier’s applicable safety data sheets (SDSs).
4