ENGLISH
EN - 20
7 - TROUBLE SHOOTING
Problems
Reasons
Solutions
The air conditioning does not
work.
There is no electricity.
Check to make sure the unit is
plugged in and the wall socket is
in the on position.
The overflow indicator displays
“FL”.
Discharge the water inside.
The ambient temperature is too
low or too high.
Recommend to use the portable
air conditioner at the temperature
of 7-35°C (44-95°C).
In cooling mode, the room
temperature is lower than the set
temperature; in heating mode,
the room temperature is higher
than the set temperature.
Change the set temperature.
In dehumidification mode, the
ambient temperature is low.
The machine is placed in a room
with an ambient temperature of
greater than 17°C (62 °C).
The cooling effect is not good.
The room is being overheated
from too much direct sunlight.
Ensure curtains and blinds are
shut.
Open doors and windows can
inhibit cooling.
Ensure doors and windows are
kept closed while the portable air
conditioner is in use.
The filter screen is dirty.
Clean or replace the filter screen.
The air inlet or outlet is blocked.
Clear obstructions.
The unit is noisy
The unit is sitting on an uneven
surface.
Ensure the portable air conditioner
is sitting on
a flat, hard surface.
Compressor does not work.
Overheat protection starts.
Wait for 3 minutes until the
temperature is lowered, and then
restart the machine.
The remote control does not
work.
The distance between the
machine and the remote control
is too far.
Move the remote control closer to
the portable air conditioner and
ensure you are in a direct line of
sight with the unit.
The remote control is not aligned
with the direction of the remote
control receiver.
Move the remote control closer to
the portable air conditioner and
ensure you are in a direct line of
sight with the unit.
Batteries are dead.
Replace batteries.
Displays ‘E2’.
The exhaust pipe temperature
sensor is abnormal.
Contact the manufacturer or
qualified service agent for
assistance.
Displays ‘E1’.
The room temperature sensor is
abnormal.
Contact the manufacturer or
qualified service agent for
assistance.
If problems not listed in the table occur or recommended solutions do not work, please contact
[email protected] for support.
This manual can be found at www.olimpiasplendid.com.au
