Olimpia splendid DOLCECLIMA Compact M, Instructions For Use And Maintenance Manual

Page: 52 / 354

EN - 20
ENGLISH
7 - INCONVENIENCES AND POSSIBLE REMEDIES
Do not try to repair the appliance by yourself.
If the problem has not been solved, please contact your local retailer or the closest assistance service.
Supply detailed information about the malfunction and the equipment version.
CAUSE
• No power.
• The plug has not been inserted.
• Timer is ON
• The temperature set is too close to
ambient temperature.
• Suction of outside air is obstructed.
• Window open.
• Some source of heat is operating in the
room (burner, lamps, etc.) or the room
is crowded.
• The temperature set is too high.
• The power of the conditioner is not
suitable for ambient conditions or
dimensions.
• The conditioner has been tilted or laid
flat.
• Excessive build-up of water inside the
conditioner
• Ambient temperature too low
WHAT DO I DO?
• Wait.
• Plug in the conditioner.
• Switch off the timer
• Lower the temperature set.
• Remove the obstructions.
• Call the Service Center.
• Close the window.
• Eliminate sources of heat.
• Lower the temperature set.
• Remove the plug (fig.2 ref. n°4) and drain
the water before moving the conditioner.
• Pull out the plug
• Call the Service Centre.
• Pull out the plug
• Call the Service Centre.
• Pull out the plug
• Call the Service Centre.
• Pull out the plug
• Dain the water contained by removing
the plug (fig.2 ref. n°4). If this alarm is
displayed too frequently, call the Service
Centre.
• Air conditioner behaviour is normal.
MALFUNCTION
• The conditioner does not work.
• The conditioner works only for a
short period.
• The conditioner works but does not
refresh the room.
• Water leaks from the conditioner
during transport.
• The conditioner switches off, the controls
on the remote control and the control
panel do not respond and alarm signal
“E1” flashes on the control panel display.
• The conditioner switches off, the controls
on the remote control and the control
panel do not respond and alarm signal
“E2” flashes on the control panel display.
• The conditioner switches off, the controls
on the remote control and the control
panel do not respond and alarm signal
“E4” flashes on the control panel display.
• The conditioner switches off, the controls
on the remote control and the control
panel do not respond and alarm signal
“P1” flashes on the control panel display.
• In cooling, night-time or automatic mode,
minimum speed cannot be selected.